Category:

Integral Double P-Seal bottom

The Tubing Head is the uppermost spool in a wellhead assembly. It provides a means to support and seal a tubing string. The upper section has a straight type bowl and a 45 degree load shoulder to support and seal the tubing string by means of a tubing hanger. There is a full set of lock-screws to safely secure the tubing hanger in the head. The lower section houses a secondary seal to isolate the production casing string and provide a means to test the wellhead seals. Threaded or weld-on tubing heads attach directly to the production casing.

  • Provides a sealing point over the production casing.
  • Allows for pressure testing of the wellhead seals to isolate the casing strings.
  • Provides a tubing hanger load shoulder and bowl for hanging and sealing of the tubing.
  • The load shoulder and bowl also accommodate a test plug.
  • Full set of lock-down pins to secure tubing hanger
  • ET style pins eliminate exposed lock-down pin threads
  • Provides two outlets for annular access and monitoring.
  • Provides a means for Wear Bushing installation and retention.
  • TC-60 bowls available for dual completions.
  • Accepts Frac Isolation Sleeves for tubing head isolation during high pressure casing frac jobs.
Outlets

  • Threaded 2” LP (LPO)
  • Threaded EUE 8rd
  • Side Studded Outlets (SSO) with internal VR prep
  • Extended Flanged Outlets (EFO) with internal VR prep

Bottom Profile

  • BG (blank); accepts a wide variety of secondary seals
  • O-ring bottom; made to specific casing sizes
  • P-Seal bottom; made to specific casing sizes and must be energized by plastic packing
  • FS bottom (high pressure) made to specific casing sizes

Bottom Connection

  • Flanged to bolt directly to casing head or spool
  • Slip-on Weld (SOW) with internal o-ring (outside weld only)
  • Slip-on Weld (SOW) no o-ring (outside and inside weld)
  • Threaded female casing thread
  • Threaded male casing thread

Bowl Profile

  • Standard TCM bowl provides a straight bowl with a 45 degree load shoulder that accepts a wide variety of single completion tubing hangers.
  • TC-60 bowl provides a straight bowl with 45 degree load shoulder with the addition of two alignment pins for dual completion tubing hangers.

Modified for Frac Isolation Sleeve

  • All flanged bottom tubing heads can be modified to accept our Frac isolation sleeve
  • Sleeve is pre-installed and tested in our facility.